• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Assignment Questions - 14218_355
Assignment Questions - 14218_357

Aircrew Survival Equipmentman 2 - Aviation theories and other practices
Page Navigation
  328    329    330    331    332  333  334    335    336    337    338  
2-54. 2-55. 2-56. 2-57. 2-58. The tacking that holds the override disconnect to the pilot parachute connector strap is tacked how far above the knot securing the connector strap to the vent lines? 1. 5±1/2 inches 2. 4±1/2 inches 3. 3±1/4 inches 4. 2±1 inches What type of thread/cord is used to tack the override disconnect to the pilot chute connector cord? 1. E thread 2. FF thread 3. 3-cord 4. 6-cord To stow the firing lanyard into the stowage sleeve, you must use what tool(s)? 1. A packing hook 2. Type I nylon line and a bodkin 3. Rubber bands 4. Type III nylon line and a screwdriver What size of thread is used to tack the second lanyard bight to the stowage sleeve? 1. A nylon thread 2. E nylon thread 3. F nylon thread 4. FF nylon thread Which of the following manuals would you use to ensure you are installing the proper arming cable and time-delay cartridge? 1. NAVAIR 13-1-6.5 2. NAVAIR 13-1-6.4 3. NAVAIR 13-1-6.3 4. NAVAIR 13-1-6.2 2-59. 2-60 2-61. 2-62 2-63. The breakcords used to secure the lift web protector flaps over the risers are constructed from 1. three-strand cord 2. four-strand cord 3. FF thread 4. E thread What type of knots are used to secure the breakcords? 1. Lark’s head 2. Surgeon’s knot and a square knot 3. Two half-hitches 4. Two half-hitches and a clove-hitch The connector link ties are constructed from (a) how many lengths and (b) what type cord? 1. (a) Two 12-inch (b) 100-pound nylon cord 2. (a) Two 14-inch (b) Type I cotton cord 3. (a) Two 24-inch (b) 150-pound nylon cord 4. (a) TWO 16-inch (b) Type III cotton cord The loop used in the connector link ties is tied with what type knot(s)? 1. Overhand knot 2. Lark’s head knot 3. Bowline and overhand knot 4. Lark’s head and overhand knot When you install the release lanyard and ripcord assemblies, YOU must ensure that the baseplate clamp is in what position? 1. To the right of the hex nut locking pin 2. Over the locking pin prior to installing the hex nut 3. To the left of the hex nut locking pin 4. Over the hex nut prior to installing the locking pin 12







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.