16, and 10 that are general-purpose bombs configured
with a wing assembly and a computer control group.
Preparation and inspection of the GBUs are the same as
the GP bombs, discussed earlier in this chapter.
Wing Assembly Installation
Install the wing assembly on the bomb as follows:
1.
Ensure safety pins are securely installed in
latch release lever and collar assembly (fig.
13-16).
2.
Remove access covers.
NOTE: Refer to figure 13-17 for steps 3
through 8.
3.
Attach Mk 3 arming wire to aft suspension lug.
4.
Insert arming wire through MAU-166 swivel
loop.
5.
Orient wings as follows:
a.
Position MXU-667 and MXU-650 wings
in X configuration with the wing release
latch mechanism at 9 o'clock, with the
bomb lugs at 12 o'clock when viewed from
the rear.
13-16
Figure 13-16.—Wing assembly.
