10-34.
Basically, what total number of
distinct steps are there to follow
in aircraft troubleshooting?
Ten
Nine
Three
Seven
10-35.
A tensiometer is used to measure
and check which of the following
items?
1.
The length of a cable
2.
The breaking strength of a
cable
3.
The amount a cable will
stretch
4.
The amount of pulling force
applied to a cable
IN ANSWERING QUESTION 10-36, REFER TO
FIGURE 9-23 IN THE TEXTBOOK.
10-36.
You are checking a l/8-inch cable
using a No. 1 riser, and the dial
pointer indicates 33.
What is the
cable tension?
1.
50 lb
2.
60 lb
3.
70 lb
4.
80 lb
10-37.
Cable tensiometer readings should
NOT be taken within what
prescribed number of inches of
turnbuckles, end fittings, or
quick disconnects?
1.
5 in.
2.
2 in.
3.
6 in.
4.
4 in.
IN ANSWERING QUESTIONS 10-38 THROUGH
10-40, REFER TO FIGURE 9-26 IN THE
TEXTBOOK.
10-38.
You should begin rigging the
system at what component?
The bobweight
The aft sector
The bell crank
The aft control stick
10-39.
While rigging the elevator control
system, you have the aft sector
rig pin in place and you find that
the elevators are 5 degrees too
low.
What action should you take
to correct the problem?
1.
Loosen the turnbuckles on the
cables
2.
Tighten the turnbuckles on the
cables
3.
Shorten the push-pull rod from
the aft sector
4.
Lengthen the push-pull rod
from the forward sector
10-40.
The maximum up and down travel of
the aircraft elevators is
controlled by the adjustment of
which of the following components?
1.
The stop bolts on the aft
control stick
2.
The stop bolts on the forward
control stick
3.
The forward push-pull tube at
the aft control stick
4.
The vertical reference line at
the forward control stick
10-41.
Aircraft control cables should NOT
be cut by which of the following
tools?
A cold chisel
A pair of side cutters
An oxyacetylene cutting torch
A pair of heavy-duty diagonal
pliers
10-42.
Swaging is the attachment of a
terminal to the end of a cable by
what means?
By soldering
By pressure
By welding
By heat
10-43.
After a cable terminal has been
swaged and measured, what manual
should you consult to determine if
it has been swaged sufficiently?
1.
NAVAIR 01-1A-8
2.
NAVAIR 01-1A-12
3.
NAVAIR 01-1A-16
4.
NAVAIR 01-1A-20
10-44.
What amount of cable should extend
through an MS 20667 terminal when
you swag it with a pneumatic
swagger?
1.
1/8 in.
2.
1/4 in.
3.
1/2 in.
4.
3/4 in.
51
