Learning Objective:
Identify CAD Maintenance
policy to include SMDC and
FCDC maintenance and
inspection requirements
and safety precautions.
3-41.
The service life of wire-braid,
Teflon®-hoses is the same as the
service life of what associated
item?
1.
The initiator to which it is
attached
2.
The aircraft in which it is
installed
3.
The CAD to which it leads
4.
The rocket motor to which it
leads
3-42.
Hoses in an escape system should
be inspected how often?
1. At every phased inspection
2. Upon removal of the seat
3. After the bases are
disconnected
4. Each of the above
3-43. For safety reasons, which of the
following devices will be
installed in CADs when CADs are
removed from an aircraft?
Figure 3-2
IN ANSWERING QUESTIONS 3–44 THROUGH
3-48, SELECT THE CLEARANCE FROM FIGURE
3-2 ABOVE, WHICH SHOULD BE USED FOR THE
STRUCTURAL DESCRIPTION PROVIDED IN THE
QUESTION. CLEARANCES USED IN FIGURE 3-22
MAY BE USED MORE THAN ONCE.
18
3-44.
3-45.
3-46.
3-47.
3-48.
3-49.
3-50.
A supported section of SMDC and
the adjacent structure.
1. A
2. B
3. C
4. D
Straight unsupported sections of
SMDC and the adjacent structure.
1. A
2. B
3. C
4. D
Two parallel SMDCs.
1. A
2. B
3. C
4. D
Unsupported sections of SMDC and
any operating mechanism.
1. A
2. B
3. C
4. D
A supported section of SMDC and
an electrical wire bundle.
1. A
2. B
3. C
4. D
When using the detonating card
inspection gauge set to check the
booster tip, what action, if any,
should you take if the bar does
not touch both sides of the
gauge?
1.
Replace the tip
2.
File the tip
3.
Replace the booster
4.
None
When using one CAD from a two-CAD
set, what information should you
mark on the unused CAD?
1.
Shelf life
2.
Expiration date
3.
Container open date
4.
Both 2 and 3 above
1. Caps
2. Plugs
3. Safety pins
4. Each of the above
