10-35.
A receiver tuned to 2.4 kHz
experiences extreme full-wave
rectification interference.
Which
of the following aircraft
components is the probable source?
1.
Starter motor
2.
Wing-flap motor
3.
Single-phase invertor
4.
Three-phase generator
IN ANSWERING QUESTION 10-36, REFER TO
FIGURE 10-1 IN THE TEXTBOOK.
10-36.
Interference is very low at the
power source for which of the
following reasons?
1.
Source operation high
frequency
2.
Source operation low frequency
3.
Battery high impedance
4.
Battery low impedance
10-37.
Which of the following actions
will reduce inductive magnetic
coupling in aircraft wiring?
1.
Increasing the spacing between
the wires
2.
Decreasing the spacing between
the wires
3.
Decreasing the angle between
the wires
4.
Replacing all the existing
wire with shielded wire
10-38.
Which of the following antenna
leads is a source of radio
receiver noise in the HF range?
1.
Shielded receiver
2.
Unshielded receiver
3.
Shielded transmitter
4.
Unshielded transmitter
10-39.
What elements are normally used to
achieve interference reduction at
the source?
10-40.
The efficiency of a perfect
capacitor in bypassing radio
interference increases in what
proportion to the capacitance of
the capacitor?
1.
Linearly
2.
Exponentially
3.
Directly
4.
Indirectly
10-41.
The value of a capacitor as a
bypass is lost at which of the
following frequencies?
1.
At the resonant frequency
2.
At frequencies much lower than
the resonant frequency only
3.
At frequencies much higher
than the resonant frequency
only
4.
At frequencies much higher and
lower that the resonant
frequency
10-42.
The ideal position to place a
capacitive filter to reduce radio
interference is in what location?
1.
Between the source of the
interference and the receiver
2.
Close to the source of
interference
3.
The receiver circuit
4.
The source circuit
10-43.
Feedthrough capacitors used to
filter interference in an ac
circuit should have a voltage
rating of at least what magnitude
across the capacitor?
1.
Twice the applied voltage
2.
Twice the peak voltage
3.
Four times the applied voltage
4.
Four times the peak voltage
1.
High-frequency diodes
2.
High-value components
3.
Discrete components
4.
Transistors
68