8-25.
8-26.
8-27.
8-28.
8-29.
8-30.
8-31.
Nylon has what percent of
moisture regain?
1.
2.5
2.
3.2
3.
4.2
4.
5.5
What is the melting point of
nylon material?
1.
382°F
2.
482°F
3.
540°F
4.
600°F
Learning Objective:
Identify and
discuss special hand tools,
grommets, and fasteners.
When installing the chuck and die
into a grommet press, the chuck
is the upper tool and the die is
the lower.
1.
True
2.
False
A properly set chuck and die will
have a clearance of how many
inches?
1.
1/8
2.
1/32
3.
1/2
4.
3/4
A carpenter’s square has arm
measurements of how many inches?
1.
12 and 24
2.
14 and 24
3.
16 and 24
4.
18 and 24
Which of the following tools is
best suited for making holes in
material that will use snaps or
speedy rivets as
1.
A hand press
2.
An awl
3.
A star punch
4.
A hot iron
fasteners?
Which of the following sizes of
grommets is the smallest?
1.
1
2.
2
3.
3
4.
4
8-32.
8-33.
8-34.
8-35.
8-36.
8-37.
8-38.
When setting a grommet, the
collar size must match the punch
size.
1.
True
2.
False
When using a grommet set to
install a grommet, what should
you use to strike the punch?
1.
A ballpeen hammer
2.
A rawhide mallet
3.
A setting maul
4.
A hand press
What is the most common type
fastener used on clothing?
1.
Velcro
2.
Three-way locking
3.
Glove fastener
4.
Curtain fastener
Which of the following type
fasteners would you use if you
needed extra security?
1.
Segma Dot
2.
Durable Dot
3.
Glove
4.
Three-way locking
Three-way locking snaps are
supplied in how many sizes?
1.
One
2.
Two
3.
Three
4.
Four
Curtain type fasteners are
available in how many sizes?
1.
One
2.
Two
3.
Three
4.
Four
Which of the following methods is
used to clean grease and dirt
from a slide fastener?
1.
MEK
2.
Toluene
3.
Soap and water
4.
Stoddard solvent
46
