5-33. What signal should D3 send to request verification and repetition of the heading? 1. 2. 3. 4. 5-34. The executive method of communication is used when the OTC desires that ships in company execute a signal at what time? 1. At stated intervals 2. At the same time 3. At random intervals 4. As soon as possible 5-35. What type of message should you use when communicating by the executive method? 1. Plaindress 2. Abbreviated plaindress 3. Abbreviated service 4. Codress 1. 2. 3. 4. 5-36. What prosign should you insert before the first BT when communicating by the executive method? 1.  IX 2. IMI 3. EX 4.  XI 1. 2. 3. 4. 5-37. What prosign should you transmit to execute a tactical signal? 1. IX IX IX 2. AR AR AR 3. EX EX EX 4. IX and a 5-second flash IN ANSWERING QUESTIONS 5-38 THROUGH 5-40. REFER TO THE FOLLOWING INFORMATION: The OTC SIGNALS IX BT TURN STBD BT K. 5-38. What maneuvering information does the signal convey to your commanding officer? 5-39. What action determines that the signal is a delayed executive message? 1. There is a single prosign IX 2. The text is sent twice 3. The receiver receipts for the message 4. The receiver does not receipt for the message 5-40. As the receiver, you read TURN as TRRN.    To correct this error, you should request a repeat of what portion of the signal? 1. The entire signal 2. The word after BT 3. All before STBD 4. All after BT 5-41. You are told by the OOD to cancel TURN PORT, the only outstanding executive method message. What message should you send to accomplish this? 5-42. If the signal TURN PORT was one of two unexecuted executive method messages, what message should you transmit to cancel it? 5-43. What part of the transmission should you repeat when signaling by the immediate executive method? 1. The text 2. The text and call up 3. The text and execute-to-follow prosign 4. The entire transmission 5-44. What prosign is used to call an aircraft? 1.  AA 2. AB 3. WA 4.  WB 1. TURN STBD has been canceled 2. TURN STBD has been executed 3. Execute TURN STBD immediately 4. Execute TURN STBD on signal 32