• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ASSIGNMENT 3-Cont.
ASSIGNMENT 4-Cont. - 14018_722

Aviation Structural Mechanic (H&S) 3&2 - How airplanes are built and how to maintain them
Page Navigation
  691    692    693    694    695  696  697    698    699    700    701  
ASSIGNMENT 4 Textbook Assignment: “General Aircraft Maintenance,”   chapter 3, pages 3-1 through 3-50. 4-1. 4-2. 4-3. 4-4. 4-5. 4-6. The Navy’s Tool Control Program is based on what concept? 1. Instant inventory 2. Cost effectiveness 3. Personal accountability 4. Tool replacement demands Ensuring that tools are procured and issued in a controlled manner consistent with the approved tool control plan is the responsibility of what officer? The maintenance officer The material control officer The quality assurance officer The assistant maintenance officer Which of the following reports should be used to report poor quality tools to FLEMATSUPPO? EI HMR CAT I QDR CAT II QDR Upon task assignment, you must record the tool container number on what copy of the VIDS/MAF? 1. Copy 1 2. Copy 2 3. Copy 3 4. Copy 5 What person is responsible for training work center personnel in the use of a material safety data sheet (MSDS)? 1. The safety officer 2. The executive officer 3. The work center supervisor 4. The maintenance control Chief To indicate a hazard that could result in injury or death to personnel if not carefully observed or followed, what safety term is used? 1. Memo 2. Note 3. Warning 4. Caution IN ANSWERING QUESTIONS 4-7 AND 4-8, REFER TO FIGURE 3-3 IN THE TEXTBOOK. 4-7. Thin lines made up of long and short dashes alternately spaced and consistent in length are known by what name? Hidden lines 2. Center lines 3. Dimension lines 4. Extension lines 4-8. Thin lines terminated with arrow heads at each end are known by what name? 1. Hidden lines 2. Leader lines 3. Extension lines 4. Dimension lines IN ANSWERING QUESTIONS 4-9 THROUGH 4-13, SELECT FROM COLUMN B THE TYPE OF DRAWING OR DIAGRAM APPROPRIATE FOR THE USE LISTED IN COLUMN A. A. USES B. TYPES 4-9. 4-10. 4-11. 4-12. 4-13. Shows an exploded 1. view Illustrates a 2. system Shows disassembly  3. Shows the sequence in which the 4. different components operate Shows detail of parts, Block diagram Schematic diagram Pictorial drawing Ortho- graphic drawing components, and other objects; used primarily by the manufacturer 4-14. A graphic representation that shows how a component fits with other components of a system but does not tell where it is in the aircraft is known as what type of diagram or drawing? Schematic diagram Pictorial drawing Installation diagram Orthographic drawing 17 1.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.