plate or decal on or near the bottle or air filler valve.
If the instruction plate is missing or not readable, the
information may be found in the General Information
and Servicing section of the applicable MIM.
Pressure should be added to air storage bottles
slowly in order not to build up heat from rapid
transfer. You should take care to ensure that air
storage bottles are not overinflated.
RECOMMENDED READING LIST
NOTE: Although the following references were
current when this TRAMAN was published, their
continued currency cannot be assured. Therefore,
you need to be sure that you are studying the latest
Aviation Hydraulics Manual, NAVAIR 01-1A-17,
Commander, Naval Air Systems Command,
Washington, D.C., 1 April 1978, Change 2, 1
December 1986, RAC 4, 15 August 1989,
Sections I, VII, VIII, and XI.
Fluid Power, NAVEDTRA 12964, Naval Education
and Training Program Management Support
Activity, Pensacola, Fla., JuIy 1990, Chapters 1,
4, 9, and 11.