• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
SUU-25 FLARE DISPENSER - 14313_331
SAFETY PRECAUTIONS - 14313_333

Aviation Ordinanceman - Aviation theories and other practices
Page Navigation
  312    313    314    315    316  317  318    319    320    321    322  
REVIEW NUMBER 2 ANSWERS A1. Mk 76 and Mods and BDU-48/B are the two subcaliber practice bombs normally used. A2. The  CXU-3A/B  day  use  and  the  Mk  4  night use  are  the  two  practice  bomb  signals  used with the Mk 76 practice bomb. A3. You  should  refer  to  NAVAIR  11-5A-17  for detailed  information  about  practice  bombs and signal cartridges. Dispenser Preparation Prepare dispenser for flare loading as follows: 1. Safety  pin  and  flag  installed  in  safety  switch (fig. 13-29). 2. Stepper switch set on safe. 3. Ensure dispenser has been electrically checked. 4. Open breech caps, ensure sleeves are clean. 5. Open   four   downloading   breech   caps   (fig. 13-30). Flare Loading Procedures Load flares into dispenser as follows: 1. Insert   forward   flare   into   tube   with   green arming cap forward, and ensure white spacer is properly  seated  on  yellow  sealing  ring  and centered.  Continue  to  push  flare  forward,  and insert aft flare with green arming cap forward until   forward   flare   is   stopped   against   the expansion chamber. 2. Close  aft  retaining  link  and  insert  shear  pin, with head of shear pin in the upward position. Spread shear pin tangs 30 to 40 degrees. 3. Rotate   applicable   forward   retaining   lock   to locked position. 4. Install shear pin into lock with pinhead forward and spread tangs to 30 to 40 degrees. 13-26 Figure 13-29.—SUU-25F/A.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.