ASSIGNMENT 1 Textbook Assignment: “Common Maintenance Tools and Their Uses,” and “Measuring Tools and Techniques”; chapters 1 and 2, pages 1-1 through 2-12. 1-1. 1-2. 1-3. 1-4. You demonstrate good work habits by doing which of the following tasks? 1. Stowing tools in their proper place 2. Using handtools for their intended purposes only 3. Protecting tools against damage, breakage, and rust 4. All of the above Ball-peen machinist’s hammers are made in different weights. They are also divided into hard-faced and soft-faced classifications. 1. True 2. False Which of the following tools is most suitable for driving a tight fitting shaft into its hole? 1. A hard-faced hammer 2. A soft-faced hammer 3. A carpenter’s hammer 4. A sledge hammer Which of the following statements best describes the effect of choking up on a hammer handle? 1. It increases the lever arm 2. It reduces the striking force of the blow 3. It produces a more effective blow 4. It makes it easier to hold the hammer upright IN ANSWERING QUESTIONS 1-5 THROUGH 1-8, SELECT FROM COLUMN B THE NAME OF THE HAMMER SHOWN IN COLUMN A. 1-5. 1-6. 1-7. 1-8. A. HAMMERS B. NAMES 1. Claw 2.    Ball peen 3.    Cross peen 4. Riveting 1-9. Which of the following is a recommended practice in the use and care of a rawhide mallet? 1. It may be used to drive nails or strike steel surfaces 2. The rawhide may be conditioned by exposure to sunlight 3. The handle may be used for prying 4. A thin coat of oil should be applied to the head before storage 1-10. What characteristic determines the size of an open-end wrench? 1. The overall length of the wrench 2. The width of the opening between the wrench jaws 3. The thickness of the wrench jaws 4. The minimum amount of “play” between the jaws 1