1-28. The
1.
2.
3.
4.
size of a micrometer indicates
the size of the largest work it
can measure
the size of the smallest work
it can measure
if it requires calibration
how often it requires
calibration
A.
Inside micrometer
B.
Outside micrometer
C.
Depth gage
D.
Dial indicator
FIGURE 1-B
IN ANSWERING QUESTIONS 1-29 THROUGH 1-31,
SELECT FROM FIGURE 1-B THE MEASURING TOOL
REQUIRED TO COMPLETE THE TASK IN THE
STATEMENT
1-29.
1-30.
1-31.
Measuring the depth of a slot in a
pump shaft.
1. A
2. B
3. C
4. D
Measuring the inside diameter of a
bushing.
1. A
2. B
3. C
4. D
Measuring the trueness of a pump
shaft.
1. A
2. B
3. C
4. D
1-32.
1-33.
1-34.
If you had to find the tightening
sequence for the bolts on a pump
casing, where should you look?
1.
On the upper half of the casing
2.
On the lower half of the casing
3.
In the ABF TRAMAN
4.
In the applicable technical
manual
What does surface corrosion look
like on painted aluminum?
1.
White or gray powdery deposits
2.
Grey or red powdery deposits
3.
An indentation on the surface
4.
The paint appears to lift off
the surface
Why is intergranular corrosion more
dangerous than other types of
corrosion?
1.
It spreads faster than other
types of corrosion
2.
It is not visible on the
surface
3.
It occurs only in the weaker
metals
4.
The powder it produces is toxic
A.
Surface
B.
Galvanic
C.
Intergranular
D.
Interior
FIGURE 1-C
IN ANSWERING QUESTIONS 1-35 THROUGH 1-37.
SELECT FROM FIGURE 1-C THE TYPE OF
CORROSION DESCRIBED IN THE STATEMENT
1-35.
It spreads through the Interior of
the metal.
1. A
2. B
3. C
4. D
4