1-37. At the intermediate level of maintenance, what copies of the VIDS/MAF are forwarded to the work center upon component induction for repair? 1. Copies 1, 2, and 3 2. Copies 2, 3, and 4 3. Copies 1, 4, and 5 4. Copies 1, 3, and 4 1-38. A component goes into an AWP status at the intermediate level of maintenance. What action is completed first with regard to the component? 1. It is stored in the work center 2. It is properly packaged and preserved 3. It is stripped of any usable parts 4. It is returned to the AWP unit 1-39. Information entered on MDS forms must always meet which of the following requirements? 1. Be typed 2. Be entered in pencil 3. Be accurate and complete 4. Be entered in pen 1-40. On-equipment maintenance actions are documented on 1. NALCOMIS or a VIDS/MAF 2. WORK REQUEST or NALCOMIS 3. DCF VIDS/MAF 4. VIDS board 1-41. The portion of an inspection that involves the search for defects is known as what phase? 1. Search 2. Fix 3. Repair 4  . Look 1-42. An organizational code, the Julian date, a sequence number, and a suffix are part of what code or control number? 1. Action Taken code 2. Job control number 3. Sequence control number 4. Work Unit Code 1-43. Maintenance was performed on an item identified by a Work Unit Code. What type of code describes this action? 1. Manufacturer’s 2. JCN 3. Malfunction 4. Action Taken 1-44. What type of code identifies a subassembly repair action that is completed separately from the major component repair action? 1. JCN Suffix 2. Type Equipment 3. support 4. Malfunction 1-45. What type of code identifies the system, specific engine, or component/part on which work is being performed? 1. Transaction code 2. Malfunction Description code 3. Type Equipment code 4. Work Unit Code 1-46. What type of code describes the trouble or cause of trouble in a system or component? 1. Transaction code 2. Action Taken code 3. Malfunction code 4. Work Unit Code 5