IN ANSWERING QUESTION 3-27, REFER TO FIGURE 3-5 IN THE TEXTBOOK. 3-27. What part of a part’s SM&R code indicates how the part is to be acquired? 1. Source code only 2. Maintenance code only 3. Recoverability code only 4. Source, Maintenance, and Recoverability codes 3-28. What position of the SM&R code identifies 3-32. What ASO publication contains a complete the maintenance level assigned to list of Navy-managed material that is completely repair an item? classified as MTR? 1. First 2. Second 3. Fourth 4. Fifth 3-29. What information does the third position of an SM&R code provide? 1. The highest maintenance level authorized to remove, replace, and use an item 2. The maintenance level authorized to completely repair an item 3. The lowest maintenance level authorized to remove, replace, and use an item 4. The Service Option code that applies 3-30. What two instructions govern policies, procedures, and definitions applicable to SM&R codes? 1. OPNAVINST 4790.2 and NAVSUPINST 4440.16 2. NAVSUPINST 4423.14 and NAVAIRINST 4423.3 3. OPNAVINST 4440.25 and NAVSUPINST 7300.6 4. NAVSUPINST 4700.16 and NAVAIRINST 4410.4 3-31. When removal of a component from an aircraft is not feasible or advisable until a replacement is on hand, supply personnel can exempt the turn-in of the component (retrograde) if its part number is listed in what document? 1. LIRSH 2. CRIPL 3 .  M C R L 4. MESSM 1. CRIPL 2. MRIL 3. IMRL 4 .  M L - N 3-33. What type of material is listed in the CRIPL? 1. Material essential for flight operations 2. Material exempt from the one-for-one turn-in rule 3. Material considered hazardous 4. Material subject to deterioration after a specified time 3-34. The reference number on a master cross- reference list refers to what number or numbers? 1. Manufacturer’s part number only 2. Drawing numbers only 3. Drawing number and design control number only 4. Either a manufacture’s part number, a drawing number, or a design control number 17