7-44.
Azimuth and elevation commands are
processed, and then applied to the
receiver head positioning motors
and gimbals by what WRA?
1.
Receiver-converter
2.
Control servomechanism
3.
Target tracking sight control
4.
Power supply-video converter
7-45.
The CS assembly inhibits the
stabilization system when LOS of
the receiver is operated by what
component?
1.
An aircraft computer,
2.
Target tracking sight control
3.
IR detecting set control
4.
FLIR detecting set control
7-46.
The BITE logic module is located in
what assembly?
1.
Power supply-video converter
2.
Control servomechanism
3.
Video indicator
4.
Target tracking sight control
7-47.
What subsystem Is NOT a power
supply-video converter subsystem?
1.
Power supply
2.
BITE
3.
Video processing
4.
Scan and interlace
7-48.
Receiver-converter synchronizing
drive and timing signals are
generated by what power
supply-video converter subsystem?
1.
Power supply
2.
BITE
3.
Video processing
4.
Scan and interlacing
1. 0°
2.
45°
3.
90°
4.
180°
7-49.
Gray scale video is displayed on
the indicator as ten different
shades of gray.
The operator uses
these shades of gray to perform
which of the following actions?
1.
Estimate the depth of the
target
2.
Calibrate the camera assembly
3.
Estimate the target’s
temperature
4.
Calibrate the TTSC
7-50.
The video processor receives raw
video signals from what device?
1. The LED array
2. The TV camera
3. The sync generator control
4. The scanning mirror
7-51.
In the BITE mode of operation, a
signal is generated to indicate
that the sync generator has failed.
This signal is generated by what
BITE module?
1.
Receiver-converter
2.
TV video
3.
IRDSC
4. CS
7-52.
To position the receiver head, the
position and rate commands from the
IRDSC are processed as
1.
analog drive signals
2.
digital drive signals
3.
clamped dc averages
4.
sync voltage pulses
7-53.
In the position mode, the azimuth
drive signal is amplified to a
signal large enough to drive the
receiver head azimuth motor by what
azimuth module?
1.
Mode logic
2.
Position compensation
3.
Rate compensation
4.
Heat sink
7-54.
In the FWD mode of operation the
receiver head is driven to what
azimuth position?
7-55.
What signal enables the azimuth
rate compensation module to accept
azimuth position rate signals from
the D/A converter only?
1.
Computer track command
2.
Rate compensation
3.
Decoder conversion
4.
Gimbal control
49
