7-56.
What is the primary difference
between the azimuth and elevation
drive subsystems?
1.
Manual override is only used
for azimuth
2.
A computer is not used for
azimuth
3.
Tachometer feedback is not used
in elevation circuitry
4.
Gimbal drive circuitry is
different
7-57.
In the FWD mode of operation, the
receiver head is slewed to what
elevation position?
1. 0°
2. -2°
3. -3°
4. -4°
7-58.
What is the primary function of the
control servomechanism BITE
subsystem?
1.
To maintain constant servo sync
pulses
2.
To automatically locate
servo-system failures
3. To isolate component failures
4.
To convert computer Inputs to
gimbal bits
7-59.
When a BITE initiate signal is
started, each test sequence lasts
what approximate length of time?
1.
10 to 12 seconds
2.
15 to 17 seconds
3.
20 to 22 seconds
4.
25 to 27 seconds
7-60.
During the fault isolate test, the
DCI fault isolate signal goes to
mode logic and
7-61.
During BITE 1 test, the receiver
head is slewed to what position?
1.
0° azimuth and 0° elevation
2.
0° azimuth and 4° elevation
3.
0° azimuth and -4° elevation
4.
4° azimuth and -4° elevation
7-62.
During BITE 2 test, the receiver
head is slewed to what position?
1.
60° azimuth and -130° elevation
2.
60° azimuth and 130° elevation
3.
130° azimuth and -60° elevation
4.
130° azimuth and 60° elevation
7-63.
The TTSC is used in what mode of
operation?
1.
Computer
2.
Azimuth
3.
Elevation
4.
Manual
7-64.
Adjusting the thumb control on the
TTSC produces voltage outputs from
which of the following transducer?
1. Rate and climb angle
2. Climb and azimuth angle
3. Elevation and rate angle
4. Elevation and azimuth angle
1.
coder storage module
2.
decoder storage module
3.
clock module
4.
memory module
50
