6-36.
In an F/A-18 aircraft, the ammunition handling
system accommodates what maximum number
of rounds?
1.
578 rounds
2.
676 rounds
3.
872 rounds
4.
1,019 rounds
6-37.
In an F/A-18 aircraft, what component limits
the total number of rounds the pilot can fire
through the M61A1 automatic gun?
1.
The rounds limiter
2.
The rounds counter
3.
The digital computer
4.
The last round switch
6-38.
In an F/A-18 aircraft, what component is used
to manually clear the M61A1 automatic gun?
1.
The clearing section clamp
2.
The clearing sector holdback
3.
The clearing sector retainer
4.
The clearing solenoid
6-39.
In an F/A-18 aircraft, the M61A1 automatic
gun system should be handled in what manner?
1.
As live ammunition
2.
As two palletized units
3.
As a single palletized unit
4.
As a separate major component
6-40.
In an F-14 aircraft, the M61A1 automatic gun
system can be operated in what mode?
1.
Air-to-ground only
2.
Air-to-air only
3.
Air combat maneuver only
4.
Air-to-ground, air-to-air, or air combat
maneuver
6-41.
In an F-14 aircraft, the M61A1 automatic gun
system accommodates what maximum number
of rounds?
1.
576 rounds
2.
676 rounds
3.
896 rounds
4.
966 rounds
6-42.
In an F-14 aircraft, what component(s) should
you use to manually clear the M61A1
automatic gun?
1.
The clearing sector clamp assembly
2.
The safety pin only
3.
The clearing sector holdback assembly
only
4.
The safety pin and clearing sector hold-
back assembly
6-43.
When removing a gun component for sudden
stoppage, you should be especially cautious
because of which of the following potential
hazards?
1.
Loose propellant powder from ruptured
cartridge cases
2.
Parts under pressure
3.
Hot hydraulic fluid
4.
Energized electrical wires
6-44.
An M61A1 automatic gun must be sent to a
depot-level maintenance activity under which
of the following conditions?
1.
When major repair is required
2.
When an alteration is authorized
3.
When 120,000 rounds have been expended
4.
Each of the above
6-45.
Which of the following gun maintenance
procedures should be accomplished during
scheduled maintenance?
1.
Lubrication
2.
Normal disassembly and parts replace-
ment
3.
A functional check of the components
based on the round interval
4.
Each of the above
6-46.
Scheduled
maintenance
for
an
M61A1
automatic gun handling and drive system
should be performed after what maximum
number of rounds has been fired?
1.
15,000 rounds
2.
20,000 rounds
3.
30,000 rounds
4.
100,000 rounds
30