BLOCK A22WORK UNIT CODE.
BLOCK A43TYPE EQUIPMENT CODE.
BLOCK A52BUREAU/SERIAL NUMBER.
BLOCK A58WHEN DISCOVERED CODE.
BLOCK A59TYPE MAINTENANCE
BLOCKS A08 THROUGH A14JOB CON-
BLOCKS E08 THROUGH E42REMOVED
ITEM(S). Enter the manufacturers code, part
number, removed date, serial number of the
removed item(s), and time cycle. If there is more
than one serial-numbered item, enter MULTI. If
there is no serial number, enter 0. A separate
VIDS/MAF work request is required for like
items that have different manufacturers code/
part numbers. In cases of egress and survival
equipment with like part numbers but different
manufacturers codes, enter five zeroes in the
manufacturers code block and the time/cycle
block using the appropriate prefix.
DISCREPANCY BLOCK, Enter descriptive
narration, serial numbers if appropriate, MRC
numbers if applicable, and signature of the
maintenance control supervisor.
The VIDS/MAF work request is delivered
with the component and/or items to the IMA
production control. The IMA production control
supervisor signs the VIDS/MAF work request
in the corrective action block and returns
a signed copy 2 (as proof of turn-in) to
the requesting activity. Copy 2 is placed on
the maintenance control/phase VIDS board until
IMA has completed the check, test, or service
VIDS/MAF WORK REQUEST
When the item(s) that have been tested,
inspected, or serviced have been reinstalled, the
documentation of the VIDS/MAF that has been
held in suspense is completed. Refer to figure 4-35
and locate each block as you read about it in this
BLOCK A35ACTION TAKEN
Enter the appropriate malfunction code.
BLOCK A39ITEMS PROCESSED. Enter
the total number of items processed.
BLOCK A41MAN-HOURS. Enter the total
number of man-hours expended for removal and
BLOCK A45ELAPSED MAINTENANCE
TIME. Enter the elapsed clock time involved in
the removal and reinstallation action.
BLOCK B30COMPLETED DATE. Enter
the Julian date on which the work was completed.
BLOCK B34COMPLETED TIME. Enter
the actual time work was completed.
CORRECTION ACTION BLOCK. Enter
Reinstalled after check, test, or service.
CORRECTED BY, INSPECTED BY,
SUPERVISOR, AND MAINT CONTROL
BLOCKS. Enter the appropriate signature and
WORK REQUEST, CUSTOMER
SERVICES (OPNAV FORM 4790/36A)
The work request, customer services form
(fig, 4-36) is used by IMA and supply department
personnel to request customer services support
from depot-level activities. Customer services
support is limited to services not involving
repairs within the capability of the requesting
The type of assistance required by the IMA
may involve the depot-level activity to complete
components delayed in process because of a lack
of facilities for check and test and/or processing
that is not normally required. Heat treatment,