IN ANSWERING QUESTION 11-43, REFER TO
FIGURE 11-14 IN THE TEXTBOOK.
11-43.
What total number of times has
this tire been rebuilt?
1.
One
2.
Two
3.
Five
4.
Four
11-44.
The vent holes in tubeless tires
are marked with what color dots?
1.
Red
2.
Green
3.
White
4.
Aluminum
11-45.
A tire and wheel assembly should
be removed from an aircraft and
sent to AIMD if it shows a
repeated pressure loss exceeding
what prescribed percent of the
correct operating inflation
pressure?
1.
5%
2.
10%
3.
12%
4.
15%
11-46.
The slippage mark on an aircraft
tire should be inspected for
slippage on the rim at what
maximum interval?
1.
Once a week
2.
Once a month
3.
After 10 flights
4.
After each flight
11-47.
Because of long intervals between
tire changes, extra care is
required when you are inspecting
mounted tires on fixed-wing
carrier-based aircraft.
1.
True
2.
False
11-48.
Before disassembling a wheel
assembly, what is the first thing
you should do?
Break the tire bead
Remove the wheel flange
Check the tire for cuts
Ensure the tire is completely
deflated
11-49.
Which of the following tire bead-
breaking machines is intended for
shipboard use?
11-50.
The inner tube of a tube-type
aircraft tire may be reused if it
is in good condition and less than
what total number of years old?
1.
5 yr
2.
6 yr
3.
7 yr
4.
8 yr
11-51.
Before inserting an inner tube
into a tire, you should sprinkle
it which of the following
substances?
1.
Flour
2.
Water
3.
Cornstarch
4.
Talcum powder
11-52.
What procedure should you use to
identify a tubeless tire?
1.
Check the inside of the tire
for an orange stripe
2.
Check to make sure the word
“tubeless” is stamped on the
sidewall
3.
Check to make sure the
manufacturer’s mold number is
preceeded with the letter X
4.
Check the tire’s serial number
with the list of tubeless tire
serial numbers
11-53.
The remote tire inflator assembly
should be calibrated upon initial
receipt, before being placed into
service, and at what other maximum
interval?
1.
Every month
2.
Every 2 months
3.
Every 3 months
4.
Every 6 months
11-54.
You have inflated a tube-type tire
to its maximum operating pressure.
The tire must remain at this
pressure for what minimum length
of time before you check it for a
pressure loss?
10 min
7 min
5 min
4 min
11-55.
What code is used to condemn a
nonretreadable tire?
1.
Lee-I
2.
Lee-II
3.
Lee-IX
4.
Lee-XX
58
