7-39.
7-40.
7-41.
7-42.
7-43.
7-44.
7-45.
The SUU-44 flare dispenser contains
what total number of dispenser
tubes?
1.
Eight
2.
Two
3.
Six
4.
Four
7-46.
When loading or unloading the
SUU-44 flare dispenser, you should
remove the breeches and breech caps
for which of the following reasons?
1.
To install cartridges
2.
To remove cartridges
3.
To prevent air-pressure buildup
4.
To permit the use of an
installation tool
As parachute flares are ejected
from the SUU-44 flare dispenser,
what components pull the safety
pins from the flare fuzes?
1.
Lockwires
2.
Drogue trays
3.
Arming wires
4.
Safety pin lanyards
A single firing impulse from the
SUU-25F/A dispenser can eject what
minimum number of aircraft
parachute flares?
1.
One
2.
Two
3.
Eight
4.
Four
What is the maximum weight of the
SUU-25F/A dispenser when it is
loaded with eight aircraft
parachute flares?
1.
260 lb
2.
435 lb
3.
490 lb
4.
572 lb
A total of how many breeches are
provided for the SUU-25F/A
dispenser?
1.
Six
2.
Two
3.
Eight
4.
Four
When the SUU-25F/A dispenser is
fully loaded, it contains what
maximum number of CCU-44 impulse
cartridges?
1.
Eight
2.
Two
3.
Six
4.
Four
7-47.
7-48.
7-49.
When loading or unloading the
SUU-25F/A dispenser, you should
remove which of the following
components?
1.
The breech and the breech cap
2.
The downloading breech only
3.
The downloading breech cap only
4.
The downloading breech and the
downloading breech cap
The stepper switch on the SUU-25F/A
dispenser has what maximum number
of settings?
1.
6
2.
2
3.
8
4.
10
When the SUU-25F/A dispenser is in
the locked position, which of the
following dispenser components
prevents loaded stores from being
inadvertently ejected by g-forces
during aircraft catapult launches?
1.
The forward retaining locks
only
2.
The aft retaining locks only
3.
The forward and aft retaining
locks
4.
The forward and aft shear
retainer pins
After the forward store is loaded
into the dispenser tube of the
SUU-25F/A dispenser, you should
rotate the forward retainer lock to
the locked position and secure it
with what device?
1.
A piece of safety wire
2.
A shear pin
3.
A cotter pin
4.
An arming wire
7-50.
What component of the SUU-25F/A
dispenser initiates the arming
sequence of a store as the store is
ejected from the tube?
1.
The arming wire
2.
The arming mechanism
3.
The aft retaining lock
4.
The forward retaining lock
7-51.
When munitions are loaded into the
tubes of the SUU-25F/A dispenser,
cross-shaped plastic spacers are
installed between munitions for
what purpose?
1.
To provide a cushion
2.
To provide an expansion area
3.
To provide a gas seal
4.
To fill in excess tube space
37