10-11. When a rocket warhead is inspected, what maximum amount of gap, if any, is allowed between the fuze adapter and the warhead? 1. 1/8 in. 2. 1/4 in. 3. 3/8 in. 4. None 10-12. When inspecting a rocket warhead with a base fuze installed, you should make sure the base fuze does NOT protrude more than what maximum distance from the warhead surface? 1. 1/16 in. 2. 1/8 in. 3. 3/16 in. 4. 1/4 in. 10-13. While inspecting a Mk 93/M414 fuze, you find minor scratches or abrasions. What action should you take? 1. Turn the fuze in to EOD 2. Replace the fuze 3. Reject the fuze 4. Use the fuze 10-14. The metal shielding band currently used to package rocket motors in separate wooden containers can be identified by what part number? 1. P/N 1516140 2. P/N 2385910 3. P/N 3958201 4. P/N 4902192 10-15. Which of the following devices should be in place whenever a rocket motor is removed or protrudes from a rocket launcher? 1. A safety clip 2. A shorting plug 3. A shielding band 4. A safety lanyard 10-16. You are using a chain wrench to install a Mk 34/Mk 63 warhead on a rocket motor and need to know what areas on the warhead you are permitted to place the wrench. What reference should you use? 1. NAVSEA OP 4 2. NAVSEA OP 5 3. The decal on the rocket 4. The decal on the warhead 10-17. The types of ordnance and the various ordnance load combinations for each model of aircraft are contained in which of the following manuals? 1. The Airborne Weapons/Stores Loading Manual 2. The NATOPS Flight/Tactical Manual 3. The CV NATOPS Manual 4. The Maintenance Instructions Manual 10-18. What manual standardizes aircraft loading procedures throughout the Navy? 1. The CV NATOPS Manual 2. The NATOPS Flight/Tactical Manual 3. The Airborne Weapons/Stores Loading Manual 4. The Maintenance Instructions Manual 10-19. A crew leader must use an aircraft weapons checklist at which of the following times? 1. When the crew leader is not qualified or certified for the particular weapon or store being loaded 2. When the crew leader is not familiar with the particular weapon or store being loaded 3. When the crew is loading inert, practice, or dummy ammunition 4. When the crew leader has a thorough understanding of the Loading Manual 10-20. Normally, which of the following weapons are armed in the arming area? 1. Rockets 2. Missiles 3. Aircraft guns 4. Rockets, missiles, and aircraft guns 10-21. Forward-firing ordnance should be dearmed at which of the following times? 1. After the aircraft’s engine is shut down and after the aircraft is refueled 2. Before the aircraft’s engine is shut down 3. After the aircraft’s engine is shut down and before the pilot leaves the aircraft 4. After the aircraft’s engine is shut down and after the pilot leaves the aircraft 53