ASSIGNMENT 10 Textbook Assignment: "Weapons Assembly," chapter 13, pages 13-1 through 13-31; "Aircraft Loading and Unloading Procedures," chapter 14, pages 14-1 through 15-32. 14-26; and "Aircraft Weapons systems," chapter 15, pages 15-1 through 10-1. The plastic shipping plugs are 10-2. 10-3. 10-4. removed from the nose well and the tail fuze cavity of Mk 80 GP bombs at which of the following times? 1. During arming procedures 2. During depalletizing procedures 3. During assembly, after fuze installation 4. During assembly, prior to fuze installation After removing a bomb from a pallet and placing it on the appropriate bomb skid or assembly stand, what action should you perform next? 1. Inspect the conical fin 2. Install a mechanical nose fuze 3. Inspect the bomb 4. Install an electrical fuze When using mechanical nose fuzing, you must install which of the following components during assembly? 1. A Mk 346 tail fuze 2. An M148 adapter booster 3. An M150 adapter booster 4. An M9 04E4 tail fuze After an M148 adapter booster has been screwed into a bomb and tightened with a spanner wrench, what step should be performed next? 1. 2. 3. 4. The setscrew in the bomb body should be tightened against the tail booster threads The hexhead bolt in the bomb body should be tightened against the adapter-booster threads The hexhead bolt in the bomb body should be removed and replaced with a safety cotter pin The setscrew in the bomb body should be tightened against the adapter-booster threads 10-5. 10-6. 10-7. 10-8. 10-9. 10-10. A Mk 122 arming safety switch should be installed in what environment? 1. A special magazine environment 2. A RADHAZ environment 3. A HERO environment 4. A RADHAZ-free environment After a Mk 3 arming wire has been installed, what device is used to hold the arming wire in place? 1. A setscrew 2. A cotter pin 3. A pop-out pin 4. A restraining clip What component retains the firing- pin assembly in a Mk 76 Mod 5 practice bomb? 1. A cotter pin 2. An arming wire 3. A retainer clip 4. A shear pin The firing device is held in the blast tube of a BDU-48 practice bomb by what means? 1. A cotter pin 2. A retainer clip 3. A safety pin 4. Threads Before a reusable rocket launcher is loaded onto an aircraft, it should be sent to AIMD for which of the following reasons? 1. Cleaning 2. A mechanical checkout 3. An electrical checkout 4. A preloading inspection During assembly, rocket warheads and motors should be kept in what position? 1. Vertical 2. Horizontal 3. Inclined 4. Raised? 52