3-22.
What mode is selected on the radar
control panels to operate the radar
antennas at a 6-RPM scan rate?
1. LONG
2.
SHORT
3. STC
4.
FTC
3-23.
On the radar control panels, what
section on the high voltage select
switch indicates to the operator
that the radar system Is ready for
use when illuminated?
1.
WARM-UP
2.
STANDBY
3.
HV OFF
4.
HV FAIL
3-24.
What selection
control panels
display when a
landmass?
1. LONG
2.
SHORT
3. STC
4.
FTC
is made on the radar
to improve the
target is near a
3-25.
What knob is adjusted on the radar
control panels to match the radar
noise levels between the forward
and aft radars?
1.
STC DEPTH
2.
STC RANGE
3.
RCVR GAIN
4. MAN TUNE
3-26.
What knob on the radar control
panels varies the amount of
receiver attenuation for close-in
targets?
1. STC DEPTH
2. STC RANGE
3. RCVR GAIN
4. MAN TUNE
3-27.
3-28.
3-29.
3-30.
3-31.
What knob on the radar control
panels varies the distance between
0 and 20 nautical miles to which
intensity of close-in targets is
effectively reduced?
1. STC DEPTH
2. STC RANGE
3. RCVR GAIN
4. MAN TUNE
With the AFC/MAN switch In the MAN
position on the radar control
panels, the radars are in what mode
of operation?
1.
Short
2.
Long
3.
Sweep
4.
Fixed
The radar scan converter control
routes the on-line/off-line
selection of
operation to
1. APP
2. RIU
3. CRS
4.
SDD
Selection of
on the radar
will disable
the radar set
what component?
the on-line operation
scan converter control
all manual selections
with the exception of the power
switch on the front panel of what
component?
1. CP
2. APP
3. RIU
4.
LU 1
What light will illuminate on the
radar scan converter control to
indicate the radar set is in the
off-line mode
1. APP
2. RIU
3. TEST
of operation?
4.
OFF LINE
17
