2-22.
What source provides the energy for the battery
positioner to operate?
1.
Hydraulics
2.
Electricity
3.
Pneumatics
4.
Electrohydraulics
2-23.
Which of the following is NOT a part of the
sheave damper assembly?
1.
The anchor assembly
2.
The buffer assembly
3.
The charging panel
4.
The damper piston
2-24.
What is the purpose of the sheave damper flow
control valve?
1.
To allow free flow of fluid from the damper
cylinder to the damper accumulator and a
restricted
flow
from
the
damper
accumulator to the damper cylinder
2.
To allow restricted flow of fluid from the
damper
cylinder
to
the
damper
accumulator and free flow from the
damper
accumulator
to
the
damper
cylinder
3.
To allow free flow of fluid to and from the
damper accumulator only
4.
To allow free flow of fluid from the damper
cylinder to the accumulator only
2-25.
What is the primary function of the purchase
cables?
1.
To transmit the landing aircraft's force to
the arresting engine
2.
To tension the crossdeck pendant
3.
To drive the control systems of the
arresting engine
4.
To retract the crossdeck pendant
2-26.
If the purchase cable payout is 72 feet, the
engine ram will travel a total of how many feet?
1.
5
2.
2
3.
3
4.
4
2-27.
What two methods can be used to operate the
retractable deck sheaves?
1.
Hydraulically and manually
2.
Pneumatically and manually
3.
Electrically and manually
4.
Hydraulically and pneumatically
2-28.
The adjustable torque limit switch is actuated
by which of the following components?
1.
The worm
2.
The tripping plate washer
3.
The torque spring
4.
The wormshaft
2-29.
What is the only function of the retractable
deck sheave limit bevel gear?
1.
To transmit the motor force to the
wormshaft
2.
To engage the lugs of the clutch bevel gear
3.
To rotate the sleeve
4.
To turn the pinion of the geared limit
switch
2-30.
The crossdeck pendant cable ends are equipped
with what type of terminals?
1.
Swaged
2.
Poured basket
3.
Fiege
4.
Clamp
2-31.
Wire supports are designed to maintain a
crossdeck
pendant
height
of
2
inches
minimum.
The maximum height should be
measured between what two points?
1.
From the top of the pendant to the deck at
the pendant's highest point
2.
From the top of the pendant to the deck at
the pendant's lowest point
3.
From the bottom of the pendant to the deck
at the pendant's highest point
4.
From the bottom of the pendant to the deck
at the pendant's lowest point
2-32.
Which of the following components is/are
NOT found in a barricade arresting engine
installation?
1.
Crossdeck pendant
2.
Sheave dampers
3.
Retractable sheaves
4.
Fluid cooler
2-33.
The
polyurethane
semicoated
barricade
webbing assembly consists of a total of how
many separate webbing systems?
1.
Five
2.
Six
3.
Three
4.
Four
9
