4-31.
The priority section of the MAF
card can be color coded to indicate
the maintenance status and
operational capability of specific
equipment. What status is
indicated if no color code is used
in the priority section?
1.
The equipment is out of
commission
2.
The equipment may be used, but
has only limited capability
3.
The maintenance is routine and
does not affect equipment
capability
4.
The maintenance has been
completed and the equipment
only needs a functional check
to be returned to full
operational capability
4-32.
On the MAF card, what color is used
for a completed maintenance action
awaiting a functional check?
1.
Blue
2.
Red
3.
Black
4.
Yellow
IN ANSWERING QUESTIONS 4-33 THROUGH 4-36,
SELECT FROM COLUMN B THE SECTION OF THE
ALRE MAINTENANCE ACTION FORM THAT WOULD
CONTAIN THE INFORMATION LISTED IN
COLUMN A.
A. INFORMATION
B. SECTIONS
4-33.
Used to document
1. Section I
4-34.
4-35.
4-36.
tool control
procedures
2. Section III
Contains equipment 3. Section VII
identification
information
4. Section VIII
including the
equipment noun
name and equipment
identification
code
Contains the job
start and stop
dates
Contains information
concerning the usage
of parts or material
4-37.
4-38.
4-39.
4-40.
4-41.
4-42.
.
What copy, if any, of the completed
ALRE MAF is retained by the
maintenance responsible work
center?
1.
One
2.
Two
3.
Three
4.
None
Who is responsible for updating and
maintaining the work center
maintenance requirement status
board?
1.
The maintenance control chief
2.
The work center group
supervisor
3.
The maintenance control officer
4.
The work center supervisor
What is the primary role of the V-2
maintenance support branch?
1.
To manage the division tool
control program
2.
To provide technical expertise
to operating work centers
3.
To reduce man-hours required to
complete maintenance tasks
4.
To manage the division man-hour
accounting program
When the Maintenance Support (MS)
branch assigns personnel to assist
in maintenance performed by the
operating work center, who
documents the MS man-hours?
1.
Maintenance Control
2.
Maintenance Support
3.
The QA branch
4.
The operating work center
The tool control program was
established to reduce the potential
of tool-related foreign object
damage and to reduce the cost of
tool replacement.
1.
True
2.
False
Which of the following is NOT a
benefit of the tool control
program?
1.
Reduced tool replacement costs
2.
Reduced equipment failures
3.
Reduced tool pilferage
4.
Assurance of tool availability
to perform maintenance
22
