IN ANSWERING QUESTIONS 6-13 THROUGH 6-15,
REFER TO TABLE 5-1 IN YOUR TEXTBOOK.
SELECT FROM COLUMN B THE COLOR FOR THE
FLARED FITTING MIL-F-5509 MATERIAL LISTED
IN COLUMN A.
NOT ALL ITEMS IN COLUMN B
WILL BE USED.
A.
MATERIAL
B.
COLOR
6-13.
Steel
1.
Blue
6-14.
Aluminum 7075
2.
Gray
6-15.
Titanium alloy
3.
Black
4.
Brown
6-16.
A commercially manufactured hose
assembly date is indicated by the
letter A, followed by what other
information?
1.
The quarter of the year and the
last two digits of the year
2.
The last two digits of the year
and the quarter of the year
3.
The last two digits of the
year, the letter Q, and the
quarter of the year
4.
The quarter of the year, the
letter Q, and the last two
digits of the year
6-17.
By what means is a commercially
manufactured Teflon® hose assembly
identified?
1. A tag
2.
A band
3.
A label
4.
A stencil
6-18.
After proof pressure testing a
locally fabricated hose assembly,
the identification tag must be
installed what distance from the
end fitting?
1. A maximum of 1/2 in.
2.
A minimum of 1/2 in.
3.
A maximum of 1/4 in.
4.
A minimum of 1/4 in.
6-19.
The fabrication of hose assemblies
is a function of what maintenance
level(s)?
1.
Depot only
2.
Intermediate only
3.
Depot and intermediate only
4.
Depot, intermediate, and
organizational
6-20.
When fabricating hose assemblies,
you should refer to which of the
following publications?
1. NAVAIR 01-1A-8
2.
NAVAIR 01-1A-12
3.
NAVAIR 01-1A-17
4.
NAVAIR 01-1A-20
6-21.
When fabricating a hose assembly,
you should lubricate the inside
bore of the hose and the outside
surface of the nipple prior to
insertion with which of the
following materials?
1.
Jet fuel
2.
Engine oil
3.
Hydraulic fluid
4.
Isopropyl alcohol
IN ANSWERING QUESTION 6-22, REFER TO TABLE
5-2 IN THE TEXTBOOK.
6-22.
When fabricating a -10 hose using
two MS24587 fittings, you must
allow what total amount of extra
hose length for the cutoff factor?
1.
1.25 in.
2.
2.00 in.
3.
2.75 in.
4.
3.00 in.
6-23.
When hose assemblies are located in
areas where temperatures exceed the
capabilities of the hose material,
you should install which of the
following items?
1. High-temp hoses
2.
Fiberglass blankets
3.
Stainless steel conduits
4.
Protective firesleeves
6-24.
What is the preferred cleaning
material for hose assemblies?
1. P-D-680, type I
2.
P-D-680, type II
3
MIL-C-43616, type I
4.
MIL-C-81309, type II
6-25.
If a hose assembly is NOT going to
be proof pressure tested
immediately after it is cleaned,
which of the following procedures
should you perform next?
1. Purge it with inert gas
2.
Fill it with hydraulic fluid
3.
Flush it with preservative oil
4.
Install protective closures on
it
29
