1-10.
Where are the test adapters stored for
the 59A120 test stand?
1.
In the storage compartment under
the stand
2.
In the accessory tray
3.
Hung on the side of the test stand
4.
Inside the accessory toolbox
1-11.
To remove dust and any foreign matter
from the surfaces of the gage tester
after removing the front panel on the
59A120 test stand, what maximum air
pressure should you use?
1.
10 psig
2.
15 psig
3.
25 psig
4.
50 psig
1-12.
When you are using air pressure for
cleaning, all interconnecting pipes,
hoses, and fittings must be cleaned
with what maximum air pressure?
1.
50 psi
2.
160 psi
3.
400 psi
4.
500 psi
1-13.
Which of the following chemicals is used
to clean the terminals, of the Liquid
Oxygen Quantity Gage Tester, on the
59A120 test stand?
1.
Type I Freon
2.
Type II Freon
3.
Type I dry cleaning solvent
4.
Type II dry cleaning solvent
1-14.
Who is responsible for calibrating the
59A120 test stand?
1.
PRs, E-6 or above
2.
Personnel assigned to depot level
maintenance
3.
On-site meteorology calibration team
1-15.
What should you use to clean the O-ring
that is installed in the bell jar?
1.
Distilled water
2.
Denatured alcohol
3.
Natured alcohol
4.
Mild soap and water
1-16.
After you clean the O-ring on the bell
jar, it should be lubricated with which
of the following?
1.
MIL G 2489
2.
MIL G 27617
3.
MIL G 6903
4.
MIL G 2873
1-17.
With of the following manuals gives
information on the procedures for
correction card preparation and
calibration?
1.
NAVAIR 13-1-6.4
2.
NAVAIR 13-1-6.5
3.
NAVAIR 17-15BC-2
4.
NAVAIR 17-17CAL-2
1-18.
Which of the following components does
NOT require a correction card?
1. PG-1
2. PG-2
3. FLM-1
4. FLM-2
1-19.
To prepare the correction cards, you must
convert the actual liter-per-minute to
1.
indicated millimeters
2.
psig
3.
inches of water
4.
inches of mercury
1-20.
After converting the actual liter-per-
minute, at what time will you enter the
indicated flows?
1.
When performing the leakage test
2.
When performing the daily test
3.
When calibrating the test stand
4.
Simultaneously
1-21.
How many graphs are supplied with the
calibration kit for the 59A120 test
stand?
1. One
2. Two
3. Three
4. Four
1-22.
How can you be sure that you have the
right graphs for the test stand you are
going to calibrate?
1.
The graphs will have the same serial
numbers as the test stand
2.
The graphs are color coded
3.
All graphs are the same
2
