4-23. Which of the following VIDs boards provides information pertaining to the divisions's overall maintenance status? 1. The   maintenance   support   work   center board 2. The Quality Assurance work center board 3. The    maintenance    control    work    center board 4. The material control work center board 4-24. A   total   of   how   many   information   display columns are required on both the maintenance control and all other work center VIDs boards? 1. Seven 2. Six 3. Five 4. Four 4-25. What color is used to indicate limited capability  on  the  Maintenance  Action  Form (MAF) cards? 1. Blue 2. Red 3. Black 4. Yellow 4-26. On   the   MAF   card,   what   color   is   used   to indicate the equipment is out of commission? 1. Yellow 2. Red 3. Black 4. Blue 4-27. The  priority  section  of  the  MAF  card  can  be color coded to indicate the maintenance status and operational capability of specific equipment.  What status is indicated if no color code is used in the priority section? 1. The equipment is out of commission 2. The equipment may be used, but has only limited capability 3. The  maintenance  is  routine  and  does  not affect equipment capability 4. The maintenance has been completed and the   equipment   only   needs   a   functional check  to  be  returned  to  full  operational capability 4-28. On  the  MAF  card,  what  color  is  used  for  a completed    maintenance    action    awaiting    a functional check? 1. Blue 2. Red 3. Black 4. Yellow 4-29. What  copy,  if  any,  of  the  completed  ALRE MAF is retained by the maintenance responsible work center? 1. One 2. Two 3. Three 4. None 4-30. Who is responsible for updating and maintaining    the    work    center    maintenance requirement status board? 1. The maintenance control chief 2. The work center group supervisor 3. The maintenance control officer 4. The work center supervisor 4-31. What is the primary role of the V-2 maintenance support branch? 1. To    manage    the    division    tool    control program 2. To provide technical expertise to operating work centers 3. To reduce man-hours required to complete maintenance tasks 4. To manage the division man-hour accounting program 4-32. When  the  Maintenance  Support  (MS)  branch assigns   personnel   to   assist   in   maintenance performed  by  the  operating  work  center,  who documents the MS man-hours? 1. Maintenance Control 2. Maintenance Support 3. The QA branch 4. The operating work center 4-33. The  tool  control  program  was  established  to reduce   the   potential   of   tool-related   foreign object  damage  and  to  reduce  the  cost  of  tool replacement. 1. True 2. False 21