4-20.
The tap switches are arranged so
voltage drops are read at the
receiver after how much float
travel ?
1.
Every 1/4 in.
2.
Every 1/2 in.
3.
Every 3/4 in.
4.
Every 7/8 in.
4-21.
Included in the primary receiver
housing are the dc power supply,
electrical slosh dampening control,
all alarm controls, and the
1.
secondary receiver
2.
indicating meter
3.
ac power supply
4.
sounding gage
4-22.
After calibration, the toggle
switch is held in the FULL REF
position and a full-scale meter
reading is observed.
What should
this reading indicate?
1.
A ground in the transmitters
2.
A ground in the receivers
3.
Bad electrical connections
4.
Cables and electrical
connections are good
4-23.
Why is a capacitor connected across
the indicating meter?
1.
To prevent meter fluctuation
caused by sloshing in the tank
2. To prevent a power surge from
damaging the indicating meter
3.
To indicate a low power supply
4.
To indicate high voltage
4-24.
The alarm control system (SENS PAK)
is normally used for indicating
what factor(s) in the tanks?
1.
High level
2.
Low level
3.
Both 1 and 2 above
4.
Overflow
4-25.
Which SENS PAK alarm control
adjustment substitutes the float
simulator circuit for the
transmitter in the indicating meter
circuit for alarm adjustment?
1.
Normal simulate switch
2.
Float simulator potentiometer
3.
High alarm potentiometer
4.
Low alarm potentiometer
4-26.
On the mimic diagram of the control
console, what color is used to
indicate the stripping system?
1.
Purple
2.
Green
3.
Red
4.
Black
4-27.
What manual contains the JP-5
systems operating procedures for a
specific ship?
1.
Technical Manual for Shipboard
Aviation JP-5 Fuel Systems
2.
Aviation Fuels Operational
Sequencing System (AFOSS)
3.
NAVSEA Technical Manual,
Chapter 542, Gasoline and JP-5
Systems
4.
Aircraft Refueling NATOPS
Manual
4-28.
What copy of AFOSS would be found
in a filter room?
1.
Division officers copy
2.
Work center copy
3.
Workstation copy
4.
Master copy
4-29.
What devices are used to completely
empty JP-5 and ballast tanks that
have been ballasted before
receiving fuel?
1.
Main eductors
2.
Transfer pumps
3.
Auxiliary pumps
4.
Stripping pumps
26