4-55.
Which valve prevents the fuel hose
from charging too quickly by
controlling the reaction time of
the fueling valve?
1.
Flow control valve
2.
SOPV
3.
Fueling pressure relief control
valve
4.
Pressure reducing control valve
4-56.
When there is an increase in the
downstream pressure that is high
enough to overcome the force of the
spring in the defueling pressure
relief control valve, which of the
following valves will open?
1.
The SOPV, both relief valves,
and the defueling valve
2.
The defueling pressure relief
control valve and the defueling
valve
3.
The pressure reducing control
valve and both pressure relief
control valves
4.
The flow control valve
4-57.
When adjusting the delivery
pressure on the Cla-Val station,
what pressure should you adjust the
pressure reducing control valve to
first?
1.
10 psi higher than the desired
delivery pressure
2.
10 psi lower than the desired
delivery pressure
3.
At the desired delivery
pressure
4.
0 psi
4-58.
When the final adjustment on the
Cla-Val is made, at what pressure
will the fueling valves pressure
relief control valve be set?
1.
10 psi higher than the delivery
pressure
2.
7 1/2 psi higher than the
delivery pressure
3.
5 psi higher than the delivery
pressure
4.
2 1/2 psi higher than the
delivery pressure
4-59.
In a swing joint, what device
4-60.
4-61.
4-62.
4-63.
connects the continuity wire to the
spider assembly?
1.
An amphonel gasket
2.
A spider joint
3.
A nylon collar
4.
An amphonel stud
What device prevents the hose reel
from moving when it is not in use?
1.
A gear chain
2.
A manual brake
3.
A locking pin
4.
An automatic catch
What is the standard length for a
completely assembled 2 1/2-inch
collapsible hose?
1.
20 ft
2.
25 ft
3.
40 ft
4.
50 ft
After cutting back and pressure
testing a fuel hose, which of the
following actions must you take
before fueling aircraft with that
hose?
1.
Flush the hose
2.
Sample the hose
3.
Test the sample on the CFD to
see if it is acceptable
4.
Each of the above
The quick-disconnect has female
threads on one end to accept the
hose coupling.
What device(s)
is/are used to connect the other
end to the male end of the nozzle
adapter?
1.
3/8-inch nuts and bolts
2.
A female ball bearing quick
release
3.
A pie flange
4.
Swedge locks
30
