To disassemble the purifier for cleaning, proceed
as follows:
1. After stopping the bowl, remove the plugs and
insert the lock screws. The two lock screws (one on
each side of the purifier) enter the slots in the bowl
shell, locking it in position.
2. Using the spring-loaded tee handle on top, un-
screw the feed tube until it is free from the paring disk.
3. Loosen the three handwheel cover clamps and
swing the bowl casing cover back until it engages the
ratchet hook. This will automatically lock the cover in
the open position.
4. Unscrew the bowl top coupling nut (fig. 4-36),
using the special tool (inset, fig. 4-36) and remove the
discharge ring and rubber ring.
Figure 4-36.—Removing bowl top coupling nut (with special tool).
4-45
