Figure 6-24.—Reworking damaged fittings.
damage not to exceed repairable limits, as shown in
rough edges or burrs, as shown in view A of figure
figure 6-24.
6-24. To repair damaged or ridged seats, resurface
circumferential ridges with annular tool, as shown in
Fittings that exceed repairable limits should be
view B of figure 6-24. Tool marks other than those of
replaced. To repair damaged fittings, proceed as
annular tools (one ten-thousandth of an inch RMS)
follows: To repair damaged orifices, remove any
are permitted on sealing surface. Damaged wrench
restriction in the orifice and handstone it to blend
pads are repaired by removing minor scratches with a
6-24
