1-46.
What iS the maximum pull force on
a ripcord pull test?
3.
1.
22 pounds
25 pounds
2.
27 pounds
4.
36 pounds
1-47.
What tool do you use to adjust
the Clip to meet the pull test
requirements?
1.
A screwdriver
2.
Pliers
3.
A ball peen hammer
4.
A setting maul
1 –48.
A pilot parachute in a parachute
assembly will become averaged 1
month prior to the next
inspection cycle.
What action
should be taken?
1. 9.0 to 11.0
2. 7.0 to 8.5
3. 4.0 to 5.0
4. 0.0 to 3.0
1.
The parachute must be
repacked 1 month early
2.
The parachute is taken out of
service
3.
The parachute remains in
service until the next repack
cycle
4.
The pilot parachute must be
replaced at the repack cycle
prior to the expiration date
1. 5 pounds
2. 10 pounds
3. 15 pounds
4. 20 pounds
1-49.
What action do you take if a
cartridge becomes overaged prior
to the next scheduled repack
inspection?
1-51.
When you test for acid and/or
alkaline contamination, what is
the safe zone on pH test paper?
1.
0
to
5.0
2.
5.0 to
9.0
3.
9.0
to 14.0
4.
14.0
to 20.0
1–52.
What is the full range of pH test
paper?
1.
0.0 to
8.5
2.
0.0 to
9.0
3.
0.0 to 10.0
4.
0.0 to 14.0
1–53.
What reading would indicate
excess alkalinity?
1-54.
When inspecting suspension lines
during an original issue
inspection,
how much tension is
applied to the lines?
1-55.
When inspecting a parachute
harness, you see a stencil on the
horizontal backstrap that reads
R-2–89.
What does this
information indicate?
1. The cartridge is replaced
prior to repack
2. The cartridge life may be
extended to govern the
inspection cycle
3. The parachute must be
repacked on the date the
cartridge expires
1. The harness is to be removed
from service in February 1989
2. The harness was reworked
February 1989
3. The harness is a replacement
harness, replaced in February
1989
4. The harness is a regular size
manufactured in February 1989
1-50.
If an emergency use canopy fails
to show a start of service date,
what will be the service life of
the canopy from the dae of
manufacture?
1-56.
If fewer than trree stitches are
broken or loose on a harness
assembly, what action, if any,
should be taken?
1. 15 years
2. 12 years
3. 10 years
4. 7 years
1. Repair it using 6 cord
2. Repair it using 3 cord
3. Repair it using FF
4. None
5
