2-43.
The NES-12
prsonnel parachute
system utilizes what type of
canopy?
1.
26-foot
2.
26-foot modified
3.
20-foot modified
4.
32-foot
2-44.
The shoulder restraint system for
the NES-12 is located on which of
the following parachute
assemblies?
1.
Riser assembly
2.
Container assembly
3.
Harness assembly
Learning Objective:
Identify
procedures for inspecting,
rigging, and packing the NES-12
parachute assembly.
2-45.
When a step iS followed by “(QA)”
in the rigging and packing
procedure, all work stops until
a quality assurance inspector
performs the requirements listed
at the end of the applicable
procedures.
1.
True
2.
False
2-46.
How do you obtain a complete
NES-12 parachute assembly to
place into service?
1.
Order the complete assembly
2.
Order each part separately
3.
Order a container and use
spare parts to assemble a
complete NES-12
2-47.
If you are in the process of
repacking a parachute and it is
time to secure, what action must
you take to complete the
repacking procedures?
1.
Complete the repack before
you secure
2.
Secure and restart the
procedure the next day from
step one
3.
Either 1 or 2 above,
depending upon the
circumstances
4.
Lay a covering over the
assembly and start at that
step the next day
2-48.
To attach the internal pilot
parachute to the NES-12 assembly,
you must use what type of
knot(s)?
1.
Bowline
2.
Square
3.
Clove hitch and a half hitch
4.
Larks head
2-49.
When positioning the spreading
gun for installation onto a
parachute canopy, it is placed
between which of the following
suspension lines?
1.
1 through 14 and 15 through
28
2.
1 through 28 and 14 through
15
3.
21 through 7 and 28 through 8
4.
7 through 14 and 28 through
21
2-50.
To route the retaining cord
through the main canopy, what, if
anything, is used?
1.
Type I suspension line
2.
Type II suspension line
3.
Type III suspension line
4.
Nothing
2-51.
When positioning the spreading
gun at the skirt hem, the gun
should be rotated so that which
labeled slug is facing up?
1.
28-1
2.
14-13
3.
12-13
4.
1-28
2-52.
What torque value is used to
secure the slug plates to the
spreading gun?
1.
5±1/2 pound-inches
2.
7±1/4 pound-inches
3.
10±1 pound-inches
4.
6±1/2 pound-inches
2-53.
What tool is used to push the
sear into the barrel of the
override disconnect?
1.
A temporary locking pin
2.
A bodkin
3.
A straight slot screwdriver
4.
A jewelers wrench
11
