Figure 4-4.—Contamination analysis kit components.
flow of fluid, take the required sample by placing a
label on the bottles that identifies the aircraft or
clean sample bottle under the fluid stream. You
equipment sampled and the specific sampling point
should take two samples at this time. In the event the
that was used.
first sample is rejected, you will have another sample
readily available. End the flow of sample fluid after
Sample aircraft filter assemblies by removing the
the sample bottles are full, and it is removed from the
filter bowl and transferring the fluid contents of both
stream. Install the caps on the bottle, and put a tag or
the bowl and the element to a clean sample bottle.
4-11
