Figure 6-44.—Initiation pull-test tools installation.
10. Lower the emergency release handle to the
control to the full UP position. Then, you remove
DOWN and LOCKED position. When you pull
the initiation pull-test tool set.
up on the ejection control handle, you can observe
that the initiation rotors move and the pull-test
Emergency Release Handle
tool extends to the relaxed position.
Assembly Check-Out
11. Stow the ejection control and reset the
The emergency release handle assembly check-
pull-test tools. You should raise the safe/arm
out may be divided into nine major steps.
6-63
