Figure 14-31.--Seal replacement and piston return adjustment.
and tighten the locknuts. Safety wire the locknuts, as
CAUTION
shown in view H.
Before applying pressure, make sure that the
brake is assembled properly with all bolts torqued
NOTE: On some brake assemblies, the adjusting
and brake discs in position. Failure to do so could
pin bushing (adjusting pin nut) is torqued to a specified
result in injury to personnel.
value.
The brake assembly must be tested following
Hold the test pressure for 2 minutes while you are
reassembly. Connect the brake assembly to a hydraulic
checking the brake assembly for leaks. Release and
supply source. Bleed the brake assembly and apply
apply the pressure 10 times to be sure that the brake
600 psi.
14-32
